Anakey wrote: ↑you do not need to include LEDS in the layout editor, you can set LED pins seperately at the bottom of the pins page
Perfect, thank you.
What doesn't make sense is the pins in the firmware builder do not match the pins on the ATmega32U4 Even when the ATMEGA32U4 is selected. They do match on the Teensy 2++ but I'm not going to be using a Teensy 2++, just the ATmega32U4. I see pins E2 and E6 on the data sheet and that's it. Firmware builder shows pins E0 through E7 but I'll be damned if I can see them on the data sheet.
Just have to figure out which ATMEGA32U4 to pick as there are several different versions with different extensions. Trying to wade through the data sheets to see what is different about each one but not much luck yet as I have no idea what page that information is on.
ATMEGA32U4-AURTR-ND
ATMEGA32U4-AURCT-ND
ATMEGA32U4-AURDKR-ND
ATMEGA32U4RC-AU-ND
ATMEGA32U4-AU-ND <----------------------( Pretty sure that's the right one )
ATMEGA32U4RC-AURTR-ND
ATMEGA32U4RC-AURCT-ND
ATMEGA32U4RC-AURDKR-ND