deskthority

Muirium wrote: 19 Oct 2021, 20:05 YOU'D NEVER HEAR ME COMPLAINING ABOUT THAT!

hehehe

Hm, interesting.


One very nice things now that things works again is that the solenoid just works now that it has qmk, never got it to work with the OG firmware (it is way too loud though, so probably won't be on too much )

Tried pulling the controller card out and putting it back in? Seems like a signal issue to me. Remember: beamspring is active low, which means zeros TRIGGER keypresses. Something may just not be connecting right.


You're completely right <3, It didn't occur to me that the controller is longer ...

Muirium wrote: 19 Oct 2021, 16:51 Try using Pandrew's web configurator I linked above. Just to see if that does the trick.

Didn't work
(Example output when keyboard is plugged in, seems to like to press a lot but not release before i disconnect it)

Did you select ixwhatsit/ibm/5251/xwhatsit_rev4 from Pandrew's layout editor?I don't have a 5251 to test this myself, but my 3276 with original Xwhatsit made controller works perfectly with Pandrew's QMK, with layouts configured and compiled on that site.

In addition to the web editor, there's ...

I just flashed my xwhatsit controller with pandrew's qmk config, as it isn't in the official repo there might be issues with it, but it claims to have better auto-calibration, but after flashing with both my own and later the default config neither worked.

It would either just press enter ...

Hi,
I recently got a Tandy 1000 keyboard module and was wondering if there is a way to make it USB compatible?