deskthority

I continually tried shorting the connection between the pads, plugging in the USB cable, and immediately/very shortly after removing the short. Not seeing the device in the Device Manager (not 100% where to look in here), but also Atmel Flip doesn't seem to see a controller. I'm getting slightly wor...

awesome, thank you Ellipse!

I really hope I didn't ruin my board.. I was trying to flash the default layout back onto the board and I used the [qmk configurator](http://35.164.28.200:5000/) site to compile and download the hex. I used the "universal" file rather than the "wcass" recommended in the manual (damnittttt). After fl...

Hahaha no, I get to keep it!!

With everything removed, the signal level monitor shows super low signal for that column. This is plugged in, not touching any of the capacitive areas. I assume this means there is a bad connection in the ribbon cable, solder joint is bad, or there is just something wrong with the controller?! image...

Yes, I did apply solder to both the controller and the PCB side. You can kinda see in my pictures that there is more/fresh solder on both sides. All tests were done outside the case. I did misplace the polyamide tape, so I'll have to cover that up before putting the back case on, but it is not causi...

I just got a compact F77 from my boss, and he sent it with the disclaimer "I've sent it in for repair, and it arrived back with keys not working". My goal is to get it working! The switches that aren't working are 2,Q,W,A,S,Z,X, and Left Alt. This is all of column 2. I have taken all the caps off, g...