deskthority

Hello,

I would print the keycap splitted in the middle (with a gap). Install the two parts and check for the (potential) angle between the two top parts. This will indicate if there are adjustments to be made in your design.

Cheers


Thanks very much, thats a good suggestion! I tried it, and ...

Not really sure where to post this, but I'm trying to 3D print a button for the lofree touch mouse. This mouse uses keycaps for buttons, though they are specific to this mouse, not standard keycaps. The left mouse button has two 'switches' (actually a single switch with 2 mounting posts) that the ...

Thanks so much (typed that bit on the Tipro, surpisingly difficult with blank keys!) I read lots of things mentioning about needing to connect direct to PS/2 and using a 32 bit system when initially setting it up, but never saw anything about needing to use the 8 pin socket. I did look previously ...

I recently purchased a couple of Point of Sale keyboards from eBay that were described as working but with no cables.

One is a Tipro / DigiPos CID-AM-KM096A-RA-002. Model on the board is a SKLOP CID-KM096AKR. This has a PS/2 and 8 pin mini DIN (I think Apple keyboard?) ports. When connected to PS/2 ...