I’m considering a custom build based on Matias switches. And since I’d be ordering switches and keycaps, I thought I might just as well use their Ergo Pro palm supports.
However, I won’t be ordering parts until I get an estimation on the case parts, and in order to ask for an estimation I’d need to present a design, and the design will substantially depend on some measurements I don’t have handy.
Namely, I need the edge length l of each of the two parts, the diameter d of the mounting holes, the distance h from the edge to centers of mounting holes (if it differs for each hole, I’d like to know that, too!), and positions of the mounting holes along the edge (determined by distances a, b and c), as shown on the figure below. (I also assume these are symmetrical; if not, that would be also nice to know.)
- palm-support-dimensions.png (70.03 KiB) Viewed 855 times
